Alcatel Carrier Internetworking Solutions omniswitch Benutzerhandbuch
Managing the Directory Structure (Non-Redundant)
Managing CMM Directory Content
page 4-16
OmniSwitch 6600 Family Switch Management Guide
March 2005
To save the running configuration to the working directory, enter the
or
command at the prompt, as shown:
-> copy running-config working
or
-> write memory
The above commands perform the same function. When these commands are issued the running configura-
tion, with all modifications made, is saved to a file called boot.cfg in the working directory.
tion, with all modifications made, is saved to a file called boot.cfg in the working directory.
Note. This command will not function if the switch is running from the certified directory. See
for an explanation.
commands are described in detail in the
OmniSwitch CLI Reference Guide.
command is executed after the
or
commands, in an OmniSwitch set up with redundant CMMs.
Note. It is important to certify the working directory and synchronize the stack as soon as the validity of
the working directory software is established. Stacks booted from the working directory or unsynchro-
nized stacks are at risk of mismanaging data traffic due to incompatibilities in different versions of switch
software. Certifying the working directory is described in
the working directory software is established. Stacks booted from the working directory or unsynchro-
nized stacks are at risk of mismanaging data traffic due to incompatibilities in different versions of switch
software. Certifying the working directory is described in