Inter-Tel CS-5200 Benutzerhandbuch

Endpoint Feature Codes

Page 121

Call Forward If No Answer/Busy

358

Forwards all calls to another endpoint or to an 
outside endpoint number if not answered 
within a predetermined amount of time, or 
immediately if the endpoint is in use.

Change Language

301

An endpoint user can change the assigned 
language for the endpoint by entering the 
Change Language feature code while the end-
point is idle.

CO Hookflash

330

Sends a timed hookflash over the trunk while 
on an outside call (includes conference calls).

Conference

5

Connects from three to four parties in a con-
ference. A conference consists of any combi-
nation of inside and outside parties. (Inter-Tel 
endpoints use the CNF button.)

Data

340

(Not used on single line endpoints) Allows 
operation of a data device attached to an end-
point that has a PC Data Port Module and a 
Modem Data Port Module (also requires a 
modem-equipped data device).

Default Endpoint

394

This single feature code cancels account 
codes for all calls following, Do-Not-Disturb, 
manual call forwarding, background music, 
ring intercom always, and queue requests; 
restores handsfree mode, pages, hunt group 
calls, and system forwarding; and returns end-
point volumes to default values.

Directories

307

(Display endpoints Only) Allows display end-
point users to search for extension numbers 
or System Speed Dial numbers. The number 
can then be dialed, if desired.

Display Outside Party Name On/
Off

379

(Display endpoints Only) When the endpoint 
user enters this feature code, while connected 
to a CO call that has outside party name infor-
mation, the display will toggle between the 
caller’s name and number. If there is no out-
side party name or the Expanded CO Call 
Information On Displays flag is disabled, the 
user will hear a burst of reorder tone and see 
the CANNOT ACCESS FEATURE display. If 
the Display Outside Party Name On/Off fea-
ture code is programmed in a user program-
mable button with a lamp, the lamp will be lit 
when the outside party name is enabled and 
off when the outside party number is enabled.

Display Time/Date (ITP)
Show IP Address (SIP)

300

(Display endpoints Only) Temporarily displays 
the system date and time, username, and 
extension number during a call or when other 
displays are shown.

Feature code 300 displays the IP Address of 
an endpoint if it is in SIP mode.