Inter-Tel CS-5200 Benutzerhandbuch

Page  40

Trunk Programming

SION OPTION, press 

 or the 

 menu button for the polar-

ity-reversal supervision type. Or, press 

 or the 

 menu button for

Valid Call timer supervision. Or, press 

 or the 

 menu button

for Valid Call timer with Polarity Reversal supervision. Then press 

 or 

to continue.

Caller ID: To enable or disable Caller ID, press 

 or the 

 menu but-

ton. When the display shows SET CALLER ID, press 

 or 

 to enable the fea-

ture, or press 

 or OFF to disable it. Then press 

 or 

 to continue.

Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press 
or the 

 menu button. When the display shows HYBRID BAL-

ANCE OPTION, press 

 or the 

 menu button, or press 

 or the

 menu button. Then press 

 or 

 to continue.

DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press  

or 

the 

 menu button. When the display shows ENTER SIG-

NALING OPTION, press 

 or the 

 menu button, or press 

 or the 

menu button. Then press 

 or 

 to continue.

Trunk Group Number: To assign the trunk to a trunk group, press 

 or the 

 menu button. When the display shows ENTER TRUNK GRP EXTEN-

SION, enter the desired trunk group number using one of the methods described on

Busy Trunk: To temporarily remove the trunk from service, press 

 or the 

 menu button. When the display shows MARK TRUNK BUSY, press 

or the 

 menu button, or press 

 or the OFF menu button. Then press 

 or

 to continue.

c.

To exit, press 

 or 

 to move backward through the prompts until you

reach the ENTER DATABASE OPTION prompt.

  5.

To Program A Trunk Group: Press 

 or the TRUNK GROUP menu button. Then

program the trunk group, as follows:

a.

The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-
ber of the trunk group to be programmed using one of the methods described on

b.

The display shows ENTER TRUNK GROUP OPTION. Select one of the following
options. To view the last three options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.

Answer Access For Day Or Night Mode: To program the endpoint(s) that will
have answer access for this trunk group for day mode, press 

 or the 

menu button. To program for night mode, press 

 or the 

 menu button. When the display shows ENTER ENDPOINT

EXTENSION, perform the procedure described on the following page. 

1.) Enter a endpoint extension using one of the methods described on 

. 

2.) The display shows the extension number and a Yes/No prompt. To include the

endpoint in the list, press 

 or the YES menu button, followed by 

. Or, to

exclude the endpoint from the list, press 

 or the NO menu button, followed

by .

3.) When the display returns to ENTER ENDPOINT EXTENSION, select

another extension number. Or, if finished programming the endpoint list, press

 or ACCEPT to continue.