HP (Hewlett-Packard) ML110 G6 Benutzerhandbuch

 

 

Removal and replacement procedures  32  

 

 

System covers 

The access panel and the front bezel are both detachable. You must remove these system covers 

before you can remove or replace a server component. 

Access panel  

The access panel must be removed to access the internal components and the non-hot-plug mass 

storage devices. 

To remove the access panel: 

1. 

Perform steps 1 through 4 of the pre-installation procedure. 

2. 

Loosen the captive thumbscrew located on the rear edge of the access panel. 

3. 

Slide the panel back about 2.5 cm (1.0 in) to release it from the chassis notch. 

4. 

Detach the panel from the chassis. 

 

 

5. 

Place the access panel in a safe place for reinstallation later.