Gateway 7400 Benutzerhandbuch
Replacing or adding a processor
57
To remove the processor:
1
Open the locking lever on the processor socket by moving the lever
slightly out to the side and then lifting it up 90 degrees.
slightly out to the side and then lifting it up 90 degrees.
2
Lift the old processor straight up and out of the socket.
To install the new processor:
1
Hold the new processor over the empty processor socket and verify that
pin 1 on both the processor and the socket are aligned. Pin 1 is near the
marked corner.
pin 1 on both the processor and the socket are aligned. Pin 1 is near the
marked corner.
2
Gently place the new processor into the socket.
3
Secure the processor by lowering the locking lever until the lever latches
into place. The processor will slip into place without pressure when
aligned correctly.
into place. The processor will slip into place without pressure when
aligned correctly.
Locking
lever
Pin 1
Processor
8508366.book Page 57 Tuesday, October 23, 2001 11:29 AM