Gateway 7210 Benutzerhandbuch

          Replacing and Adding Internal Devices

The control panel board is mounted on the front of the chassis, behind the 
front bezel.

Turn off the system and disconnect the power cord and all external 
peripherals.

Open the case. (See “Opening the case” on page 23 and “Preventing static 
electricity discharge” on page 22.)

Disconnect the front panel connector from the control panel board.

Remove the screw that secures the board to the front of the chassis.

Lift the control panel board off of the hooks on the front panel and 
remove it.

Install the new control panel board by placing the mounting slots of the 
control panel board on the tabs on the front of the chassis, then slide 
the board down until it locks into place. Be careful to keep the front panel 
cable out of the way as you install the board.

Replace the screw you removed in Step 4.

8505945.book  Page 74  Thursday, March 9, 2000  2:13 PM