Fujitsu TX200 Benutzerhandbuch
46
Chapter 2 Checking before OS Installation
2.1.2 Hardware Settings
Before starting installation, set necessary hardware, such as the BIOS Setup Utility.
■ BIOS Setup Utility
The BIOS Setup Utility must be set in the following cases. For details on how to set the BIOS Setup
Utility, refer to "8.2 BIOS Setup Utility" (
●
Changing the Boot Drive
To change the boot drive, start up the BIOS Setup Utility, select [Boot Option], and set the boot drive.
●
Performing Remote Installation
Before performing remote installation of ServerStart, use the following procedures to enable network
startup (PXE). In addition, check the MAC address.
1
Take the following steps in the BIOS Setup Utility.
1. Start the BIOS Setup Utility.
2. Select [Boot Options] and press the [Enter] key.
The Boot Options menu window appears.
3. Change [MultiBoot for HDs] to [Enabled].
4. Press the [Esc] key and select the [Advanced] menu.
5. Select the [Peripheral Configuration] submenu and change [LAN Remote Boot] to
[PXE].
6. Press the [Esc] key. Select [Save Changes & Exit] from the [Exit] menu to exit the
BIOS Setup Utility.
7. Start the BIOS Setup Utility again.
8. Select the [Boot Option] submenu from the [Main] menu. Press the [Enter] key.
The Boot Option submenu window appears.
9. Change the [Boot Sequence] settings as shown below.
10. Exit the BIOS Setup Utility and turn the server off.
2
Check the MAC address.
Start up the server from the network.
The MAC address is displayed as shown below.
The MAC address is required for remote installation. Write it down.
1 BootManage PXE, Slot 0400
2 CD-ROM
3 Removable Device
4 Hard Drive
CLIENT MAC ADDR: XX XX XX XX XX XX