SharkRack PWS-77120 Benutzerhandbuch

05/20/03 Rev 1.0

Page 2 of 3

A vertical power strip is used to supply 
power to devices needing AC power.

Note: A vertical power strip can be 
installed on either side of the cabinet.

1. Open the rear door of the cabinet and 

choose a location for the vertical power 
strip to be mounted.

2. Install the spring nuts into the cabinet 

frame. Fit the spring nuts into the 
slotted part of the cabinet extrusion with 
the spring going into the opening first. 
Turn the spring nut 90 degrees, 
clockwise, to secure it into place.

3. Place the vertical power strip into the 

rack cabinet. Align the mounting holes 
top and bottom over the spring nuts.

4. Secure the vertical power strip to the 

cabinet frame using (2) 1/4-20 x 3/8 
inch cap screws using a 3/16 inch Allen 
wrench to tighten the cap screws.

5. Connect all necessary cables to the 

facilities power grid or UPS.

6. Check the function of the vertical power 

strip. Connect a device to each 
receptical on the vertical power strip to 
check for power.

Note: The vertical power strip has a 
resettable circuit breaker. When the 
breaker trips the center button will extend 
from the breaker housing. Depress the 
button back in to reset.