Toshiba Satellite R10 Benutzerhandbuch

To check if the modem is defective or malfunctioning, follow the troubleshooting procedures 
below as instructed. 

Procedure 1:  Diagnostic Test Program Execution Check 

Procedure 2:  Connector Check and Replacement Check 

 

Execute the Modem test program available as part of the maintenance test program. This 
program checks the modem. See Chapter 3 for information on how to perform the test. 

If any error is detected by the test, go to Procedure 2. 

The Modem jack (RJ11) is mounted on the system board and MDC is connected to the system 
board. If the modem malfunctions, the connection may be bad or the MDC or system board 
might be faulty. 

Disassemble the computer following the steps described in Chapter 4 and perform the 
following checks: 

Check 1 

Make sure the MDC is firmly connected to the PJ3020 and the MDC cable is 
connected to the PJ3021 on the system board.  

 

If any connector is disconnected, connect it firmly and return to Procedure 1. If 
there is still an error, perform Check 2.

 

Check 2 

The MDC may be faulty.  Replace it with a new one following the steps in Chapter 
4. If the modem is not still working properly, perform Check 3. 

Check 3 

The system board may be faulty.  Replace it with a new one following the 
instructions in Chapter 4.