Fujitsu FI-4120C\C2 Benutzerhandbuch

Fujitsu SCSI Scanner Installation Procedures   

Windows 95\98\98SE\ME\2000\XP  

 

Rev051906A

  

 

Page 1 of 7

 

If you are installing the following models by means of the SCSI interface then use this 
document. 
 
SP10C 

 

 

 

 

If you are going to use the USB interface of a dual SCSI/USB model then use the USB scanner 
installation guide.  For Scansnap models please use the Scansnap installation guide.   
 
 
Hardware requirements. 
 
You will need a PC system that meets our recommended specifications, an appropriate SCSI 
controller, and a SCSI cable (six foot recommended maximum).  For recommended PC system 
specifications and SCSI controllers please reference the 

You may also need your Operating System Disk. 

 
 

Step A:  Installing the SCSI Host Adapter (Adaptec). 
 

1.  Shut down your PC and remove the case cover. 
2.  Locate a free PCI slot and remove the back plate if necessary. 
3.  Install the SCSI controller in an open PCI slot. 
     Make sure that the card is seated completely in the slot and secured in the frame 
 
Warning!  Failure to secure the SCSI controller in the PC can result in damage to the 
SCSI card, scanner, and/or your system. 
 
4. Boot your PC without the scanner attached

. 

 
 

Step B: Installing the SCSI drivers (Adaptec). 

 

5.  When the New Hardware wizard comes up, allow Windows to finish installing the 

hardware files for the SCSI controller. 

6.  Then either install/update the ASPI drivers from the CD or go to 

, 

and click on the “search” tab.   

7. For Windows 95\98 or ME scroll down to the “Enter key word or quoted phrase” box 

and type in “aspi32”.   

8.  Next scroll down to the drivers section, click on ASPI32 and follow the prompts to 

download it your desktop or a new folder. 

9.  Afterwards go to that location and double click on the "aspi32.exe" icon and follow 

the prompts. 

10. When the message “ASPI is up to date” appears, reboot and go to the next step.