Datalogic Scanning 3200VSI Benutzerhandbuch

Getting Started

TM

The scanner kit you ordered to match your interface should provide a compatible cable for your 
installation. Alternatively, if your scanner receives Power Off the Terminal (POT) it might be 
possible to connect using a cable from a previously existing installation (except for USB). If you 
wish to connect using an existing cable, but cannot use POT, a short adapter cable is available. 
Check with your technical support representative about compatibility before connecting. Use 
the appropriate instructions below when you’re ready to connect the scanner to the terminal, PC 
or other host device. 

Upon completing the connection via the appropriate interface instructions below, proceed to 
the 

 section of this manual and scan the bar code to select the correct 

interface type.

Turn off power to the terminal/PC and connect the scanner 

to the terminal/PC serial port via the RS-232 cable as shown in 

a. If the terminal will 

not support POT (Power Off the Terminal) to supply scanner power, use the approved power 
supply (AC Adapter) as shown in 

b. Plug the AC Adapter barrel connector into the 

socket on the RS-232 cable connector and the AC Adapter plug into a standard power outlet.