Epson 10000XL Benutzerhandbuch

Using Optional Equipment

This section explains how to install the optional Network Image Express interface 
card (B12B808393) in your scanner. 

Before connecting the scanner to your network, make sure any computer you want to 
use for scanning is set up properly. Check that:

■

an Ethernet network card is installed in the computer

■

the computer is configured to use the TCP/IP network protocol

■

your scanner software is installed (see the Start Here sheet for instructions)

For instructions on installing your computer’s card, see the manual that came with 
the card. For instructions on setting up TCP/IP, see the 

Expression 10000XL 

Reference Guide

 on your computer.

1. Turn off the scanner and disconnect the power cord and any cables.

2. Remove the two screws securing the shield plate to the scanner’s optional interface 

slot, and then remove the plate. Keep the screws and shield plate in case you want 
to reinstall them later.

3. Fully insert the Network Image Express card in the slot, and tighten its screws. 

Caution: Do not insert the card with the scanner turned on, or you could damage 
the card or the scanner.