Opticon CRD972X Benutzerhandbuch

THIS PART DESCRIBES THE NETWORK 
DETAILS. FOR CONNECTION DETAILS REFER 
TO PREVIOUS PAGE.

TAKE NOTICE OF THE NECESSARY 
PRECAUTIONS THAT NEEDS BE MADE TO 
ESTABLISH A PROPER NETWORK 
CONNECTION AS DESCRIBED BELOW.

Connect RS232
Only 1 multicradle in the network will be connected 
to the PC through one RS232 cable. For RS232 
interface use the left RS232 connector (RS232C-
1). Through this connection all multicradles can 
communicate to the PC.

Connect RS485
A maximum of 16 multicradles can be connected in 
a network through RS485 cables.

Set DIP switch settings
For (default) settings notice DIP switch table in the 
next chapter.
• All multicradles in the network need to be set to 

RS232/RS485 connection.

• All multicradles need to have the same baud rate 

to be set by DIP switch.

• The first and the last multicradle in the network 

must have the termination resistors set.

LED indicator
Typical LED indications are:
red: power is on
flashing green: collector sends to host
flashing yellow: host sends to collector

MASTER
RS232/RS485 
TERMINATE

SLAVE
RS232/RS485 

SLAVE
RS232/RS485 
TERMINATE

ON

1    2    3    4    5    6