Sharp MX-FX13 Benutzerhandbuch

• Scanning begins.
• If the line is free, the machine will dial the receiving 

machine and begin transmission as soon as the first 
page is scanned. (Quick online transmission: page 
24)

• If there is a previously stored job or a job is in 

progress, or if the line is being used, all pages of the 
original are scanned into memory and stored as a 
transmission job. (This is called memory 
transmission: the destination is automatically called 
and the document transmitted after previously stored 
jobs are completed.)

If scanning is completed 
normally, the following 
screen is appears briefly 
and then the display 
returns to the base 
screen.

Scanning begins.

• Repeat this sequence until all pages have been 

scanned.

• You can change the resolution and exposure 

settings as needed for each. (page 14)

• If no action is taken for one minute (the [START] key 

(

) is not pressed), scanning automatically ends 

and the transmission job is stored. (This function can 
be disabled in the system settings.)

Open the SPF/RSPF and remove the original. When 
the original is removed or any key operation is 
performed, the display returns to the base screen. 
(The destination is automatically called and the 
document transmitted after any previously stored jobs 
are completed.)

MNO

WXYZ

@.-_

AD-END

READING          XX%
No.001         P-XXX

   MEMORY    AUTO
 CONT        A4R
 STANDARD

AUTO

READ END         XX%
No.001         P-XXX

   MEMORY    AUTO
 CONT        A4R
 STANDARD

AUTO

MNO

WXYZ

@.-_

AD-END

READING          XX%
No.001         P-XXX

   MEMORY    AUTO
 CONT        A4R
 STANDARD

AUTO

[START]:CONTINUE

    [#]:READ-END

   MEMORY    AUTO
 CONT        A4R
 STANDARD

AUTO

@.-_

READ-END

CC. #-C

READ END         XX%
No.001         P-XXX

   MEMORY    AUTO
 CONT        A4R
 STANDARD

AUTO

• To cancel transmission

To cancel transmission while "READING" appears or before the 

 key is pressed, press the [C] or [CA] key. To 

cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as explained 
on page 25.

• A job number (3 digits) appears in the display with "READ END" when memory transmission is performed. If 

you make a note of this number after performing a broadcast transmission, you can use the number to check 
the results of the transmission in the transaction report or activity report.

• If the power is turned off or a power failure occurs while an original is being scanned in the SPF/RSPF, the 

machine will stop and an original misfeed will occur. After power is restored, remove the original as explained 
in "MISFEED IN THE SPF/RSPF" in the Operation Guide for the machine.