Canon DS126251 Benutzerhandbuch

Seite von 276
109
Although using the self-timer or Remote Switch can prevent camera 
shake, using mirror lockup to prevent camera vibrations (mirror shock) 
can also help when you use a super telephoto lens or shoot close ups.
When [8C.Fn III -13: Mirror lockup] is set to [1: Enable] (p.215)
shooting with mirror lockup will be possible.
Focus the subject, press the shutter button completely 
and let go of it.
X
The mirror will swing up.
Press the shutter button completely again.
X
The picture is taken and the mirror goes back down.
Mirror LockupN
 
In very bright light such as at the beach or ski slope on a sunny day, take 
the picture promptly after mirror lockup.
 
Do not point the camera toward the sun. The sun’s heat can scorch and 
damage the shutter curtains.
 
If you use bulb exposures, the self-timer, and mirror lockup in 
combination, keep pressing the shutter button completely (self-timer 
delay time + bulb exposure time). If you let go of the shutter button 
during the self-timer countdown, there will be a shutter-release sound. 
However, this is not the actual shutter release (no picture is taken).
 
When [1: Enable] is set, single shooting will take effect even if the drive 
mode is set to continuous.
 
When the self-timer is set to <Q> or <k>, the picture will be taken 
after 10 sec. or 2 sec. respectively.
 
The mirror locks up, and after 30 seconds, it will go back down 
automatically. Pressing the shutter button completely again locks up the 
mirror again.
 
For mirror lockup shots, using the Remote Switch RS-80N3 or Timer 
Remote Controller TC-80N3 (both sold separately) is recommended.
 
You can also lockup the mirror and shoot with a remote controller (sold 
separately, p.110). With Remote Controller RC-1, setting it to a 2-sec. 
delay is recommended for shooting.
COP
Y