Sony PCS-TL33 Benutzerhandbuch

Seite von 129
75
Using Video From Connected Equipment for a Conference
  Chap
ter
 5
  
Dat
a
 Conf
eren
c
e
 Us
in
g Da
ta
 S
o
lut
ion
 Mo
dule
While you are transmitting a computer picture, you cannot 
receive a still image or a computer picture from any other 
terminal. Ending your transmission enables you to receive 
it. While you are receiving a still image or computer 
picture from any other terminal, you cannot transmit a 
computer picture.
Picture quality of the Data Solution Module
The picture quality received by the remote party varies 
depending on the type of terminal and connecting method, 
and the “Monitor Out (or Sub Monitor Out)” settings at the 
remote site. Using a Data Solution Module also on the 
remote site enables reception of a high-quality computer 
picture with a higher frame rate.
When the PCS-TL33 or PCS-TL30 is used as a receiving terminal
When the PCS-TL50 is used as a receiving terminal
Note
Data Solution Module attached
Resolution
Video 
frame rate
Picture quality
No (Display on the PCS-TL33 or 
PCS-TL30)
a
Outputs the signal by converting a transmitted VGA, SVGA or 
XGA signal into an XGA signal. The high-resolution picture 
can be obtained. The number of frames displayed per 
second depends on the interface transmission rate. For 
example, one frame per second is obtained.
Yes
Outputs the signal by converting a transmitted VGA, SVGA or 
XGA signal into an XGA signal. The high-resolution picture 
can be obtained. You can view a more vivid picture than the 
picture output from the display on the Video Communication 
System. The number of frames displayed per second 
depends on the interface transmission rates. For example, 
five frames per second are obtained at 1 Mbps.
Note
Three frames per second are obtained for a transmitted XGA 
signal.
: High, a: Middle, f: Low
Output connector for a computer 
picture on receiving terminal
Resolution
Video 
frame rate
Picture quality
Display on the PCS-TL50
a
Outputs the signal by converting a transmitted VGA, SVGA 
or XGA signal into an XGA signal. The high-resolution 
picture can be obtained. The number of frames displayed per 
second depends on the interface transmission rate. For 
example, one frame per second is obtained.
RGB OUT on the PCSA-DSB1S 
(only when the PCSA-DSB1S is 
enabled)
Outputs the signal by converting a transmitted VGA, SVGA 
or XGA signal into an XGA signal. The high-resolution 
picture can be obtained. You can view more vivid picture than 
the picture output from the RGB OUT connector on the Video 
Communication System. The number of frames displayed 
per second depends on the interface transmission rates. For 
example, five frames per second are obtained at 1 Mbps.
Note
Three frames per second are obtained for a transmitted XGA 
signal.
: High, a: Middle, f: Low