Polycom RMX 2000 Benutzerhandbuch
Chapter 2-First Time Installation and Configuration
2-8
3
In the lan.cfg file, modify the following parameters using the
information supplied by your network administrator. Make sure that
there are no extra spaces at the end of each line.
—
Management (Control Unit) IP Address
—
Management (Control Unit) Subnet Mask
—
Management (Control Unit) Default Gateway
—
Shelf Management IP Address (Switch)
—
Shelf Management Subnet Mask
—
Shelf Management Gateway
4
Save the file.
Procedure 3: First-time Power-up and Connection to MCU
To power-up for the first time using the USB key:
1
1
Insert the USB key containing the modified IP addresses in USB port
on the RMX’s back panel.
2
Power the RMX On.
The parameters in the lan.cfg file are uploaded from the USB key to
The parameters in the lan.cfg file are uploaded from the USB key to
the RMX’s memory and applied during the power-up sequence.
Power-up is complete when the red HD Active LED starts blinking.
Power-up is complete when the red HD Active LED starts blinking.
3
Remove the USB key.