Panasonic AWHE60SE Benutzerhandbuch
21
Preset memories
(continued)
When performing the operations using the controller
When the AW‑RP655 is connected:
Up to 50 settings can be registered and called.
The [1] to [50] buttons of [TRACING/PRESET MEMORY]
correspond to the unit’s preset memories No.1 to No.50.
The [1] to [50] buttons of [TRACING/PRESET MEMORY]
correspond to the unit’s preset memories No.1 to No.50.
p
q Registering the settings in the preset memories
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Set to the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3
Display the picture to be shot on the monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
determine the camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
4
Hold down the [MEMORY] button.
The buttons among the [1] to [50] buttons of [TRACING/
PRESET MEMORY] in which settings can be registered
now start blinking in sequence.
PRESET MEMORY] in which settings can be registered
now start blinking in sequence.
p
Preset memory settings cannot be registered in
buttons whose lamps are off (since they contain
tracing memory settings).
tracing memory settings).
5
With the [MEMORY] button still held down,
press the button of the preset memory number
in which the setting is to be registered.
press the button of the preset memory number
in which the setting is to be registered.
p
q Calling the settings of the preset memories
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Press the button among the [1] to [50] buttons
of [TRACING/PRESET MEMORY] in which the
setting was registered.
of [TRACING/PRESET MEMORY] in which the
setting was registered.
p
q Erasing preset memory settings
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Set the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3
Hold down the [RESET] button.
The buttons among the [1] to [50] buttons of [TRACING/
PRESET MEMORY] whose settings can be erased now
start blinking in sequence.
PRESET MEMORY] whose settings can be erased now
start blinking in sequence.
p
The settings for the buttons whose lamps are off
cannot be erased (since they contain tracing memory
settings).
settings).
4
With the [RESET] button still held down, press
the button of the preset memory number whose
setting is to be erased.
the button of the preset memory number whose
setting is to be erased.