Hotpoint SHS53X Benutzerhandbuch

width cm 43.5 
height cm 32 
depth cm 41.5 

lt. 58 

voltage: 230-240V ~ 50/60 Hz or 
50Hz  (see data plate) 
maximum power absorbed 
2250-2400W

 

Directive 2002/40/EC on the label 
of electric ovens.  
Standard EN 50304 

Energy consumption for Natural 

convection – heating mode: 

a

 

Convection mode 
 
Declared energy consumption for 
Forced convection Class – heating 

mode: 

b

 Multi-cooking 

 

This appliance conforms to the 
following European Economic 
Community directives:  
- 2006/95/EEC of 12/12/06 (Low 
Voltage) and subsequent 
amendments; 
-2004/108/EEC of 15/12/04 
(Electromagnetic Compatibility) and 
subsequent amendments; 
- 93/68/EEC of 22/07/93 and 
subsequent amendments. 
- 2002/96/EC and subsequent 
amendments. 

The electrical connection to the mains must be made
on the appliance.  The power voltage and frequency
are as indicated on the rating plate.

1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
(

see diagram

).

2. Install the power
supply cable by

loosening the cable
clamp screw and the
three wire contact
screws L-N-

.

Connect the wires to
the corresponding
terminals: the Blue wire
to the terminal marked
(N), the Brown wire to
the terminal marked (L)
and the Yellow/Green
wire to the terminal

marked 

  (

see diagram

).

3. Secure the cable by fastening the clamp screw.
4. Close the cover of the terminal board.

Voltage Frequency: 230 V-1+N  50Hz
Fuse Section: 16A
Supply cable: 3x1.5mm

2

You can connect your oven to the system means of
a terminal board. Refer to above information for the
minimal cable sections and the calibration of the
protective elements according to the connection.
If the appliance is installed with a junction box, an
omnipolar circuit breaker

 - with a minimum contact

opening of 3mm - should be installed between the
appliance and the mains.

We recommend you use a power supply cable which
is long enough to allow you to take the oven out of
its recess in the event of maintenance operations
(only use HAR - H 05 - RRF quality cables fitted with
a plug conforming to the regulations in force.
The plug must be accessible at all times.