Diamondback DPLS1 Benutzerhandbuch

Seite von 6
1
DPLS1
  
Drain Panel Level 
Sensor/Control 
 
Installation Instructions
 
DPLS1
Drain Pan Level
Sensor/Control
Installation Instructions
                                                  
Provides electronic overflow protection for Drain Pans in all Mr. Slim and CITY 
MULTI indoor units – MFZ, MS, MSY/Z, SEZ, SLZ, PCA/PCFY, PDFY, 
PEA/PEAD/PEFY, PKA/PKFY, PLKA/PLFY, PMFY, and PVFY 
   Meets requirements as listed alternative to secondary drain pans in all indoor unit installations covered by the                     
International Mechanical Code and adaptations. 
DPLS1 – COMPONENTS
            
           
           
             Control Box
            Water Sensor                          Splice Connector                          M2 Wire Harness
              
              
           P Wire Harness
                    M1 Wire Harness
            
        
           
             
            
 
                          
 
                          
              
The DPLS1 is powered by a twenty-year life 
Lithium battery, which has been factory, installed 
prior to shipment. This allows installation of the 
sensor and control to be accomplished without 
needing external electric power for operation.
There is an audible indication of low battery 
condition. Should the battery ever need to be 
replaced at any time see the BATTERY 
INSTALLATION INSTRUCTIONS in this document.
 
Work Safe, READ THIS!
   
ATTENTION: FAILURE TO READ AND COMPLY WITH ALL WARNINGS, CAUTIONS AND INSTRUCTIONS PRIOR TO STARTING 
INSTALLATION MAY CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE AND VOID WARRANTY.
This device must be installed in accordance with Equipment Manufacturer’s instructions and in accordance with all applicable local codes, 
including plumbing, drainage and electrical.
 
UL
UL
 
Work Safe, READ THIS! 
ATTENTION: FAILURE TO READ AND COMPLY WITH ALL WARNINGS, CAUTIONS AND INSTRUCTIONS PRIOR 
TO STARTING INSTALLATION MAY CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE AND VOID 
WARRANTY.
The DPLS1 is powered by a twenty-year life Lithium battery, 
which has been factory, installed prior to shipment. This allows 
installation of the sensor and control to be accomplished without 
needing external electric power for operation. There is an audible 
indication of low battery condition. Should the battery ever need 
to be replaced at any time see the BATTERY INSTALLATION 
INSTRUCTIONS in this document.
3400 Lawrenceville Suwanee Rd
Suwanee, GA 30024
Tele: 678-376-2900  
Service: 877-391-2900
www.mehvac.com
The DPLS1 Drain Pan Level Sensor / Control provides protection against drain pan overflow in 
Mitsubishi Electric Mr. Slim and CITY MULTI Indoor Units. The unit will sense a high condensate 
level in the drain pan. Should this occur the control shuts down the indoor unit before an overflow 
can occur. A thermistor error code will be produced should the DPLS1 activate indicating a fault 
which must be resolved before the unit will re-start.  
 
This unit provides electronic overflow protection for Drain Pans in all Mr. Slim and CITY MULTI 
indoor units: MFZ, MS, MSY/Z, SEZ, SLZ, PCA/PCFY, PDFY, PEA/PEAD/PEFY, PKA/PKFY, PLA, 
PLKA/PLFY, PMFY, and PVFY.
Meets requirements as listed alternative to secondary drain pans in all indoor unit installations 
covered by the International Mechanical Code and adaptations.
This device must be installed in accordance with Equipment 
Manufacturer’s instructions and in accordance with all applicable 
local codes, including plumbing, drainage and electrical
© 2011 Mitsubishi Electric & Electronics USA, Inc.