Grizzly H0592 Merkblatt
Introduction
An excellent air sander that has a free speed of
4,500 RPM. Requires 90 PSI and consumes 12
CFM. Spindle thread nut is
4,500 RPM. Requires 90 PSI and consumes 12
CFM. Spindle thread nut is
5
⁄
8
" x 11 UNC. Weighs
6.5 lbs. Pad size is 7". Air inlet is 1/4" NPT.
Inventory
A. Air Sander .................................................. 1
B. Pin-Type Spanner Wrench ......................... 1
C. Flat Wrench 19mm ..................................... 1
D. 7” Sanding Pad .......................................... 1
E. Lock Nut ..................................................... 1
F. Handle ........................................................ 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in
regulator as shown in
Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in
directly into the air fitting as shown in
Figure 3.
MODEL H0592
7" ANGLE SANDER
INSTRUCTION SHEET
Figure 1.
Model H0592.
Figure 3.
Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
call our Tech Support at: (570) 546-9663.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TR7971 PRINTED IN TAIWAN
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
EXPLOSION HAZARD!
Never exceed 120 PSI.
Quick
Connector
Connector
Quick
Coupler
Coupler
Air Hose
Quick
Coupler
Coupler
Quick
Connector
Connector
Lubricator
Filter
Regulator
Air
Compressor
Your
Tool
Figure 2.
Installing your tool.