Porter-Cable PCB370SS Benutzerhandbuch

5

1. 

READ AND UNDERSTAND all safety instructions 

and operating procedures throughout the manual.

2. 

DO NOT OPERATE the Scroll Saw until it is 

completely assembled and installed according to the 
instructions.

3. 

SHOULD any part of Scroll Saw be missing, 

damaged, or fail in any way, or any electrical 
component fail to perform properly, shut off the 
switch and remove the plug from the power supply 
outlet. Replace missing, damaged, or failed parts 
before resuming operation.

4.   

IF YOU ARE NOT thoroughly familiar with the 

operation of a Scroll Saw, obtain advice from your 
supervisor, instructor or other qualified person.

 
5. 

SERIOUS INJURY could occur if the tool tips over 

or you accidentally hit the cutting tool. Do not store 
anything above or near the tool.

6. 

AVOID INJURY from unexpected saw movement. 

Place the saw on a firm level surface where the 
saw does not rock and bolt or clamp the saw to its 
support.

7. 

FASTENED to a stand or workbench. If there is 

any tendency for the stand or workbench to move 
during operation, the stand or workbench MUST be 
fastened to the floor.

8. 

THIS SCROLL SAW is intended for indoor use only. 

9. 

TENSION BLADE PROPERLY before starting the 

saw. Recheck and adjust tension as needed. 

10.

BLADE TEETH MUST POINT downward toward the 

table. 

11.

TABLE MUST BE CLEARED of all debris before 

operating saw. Do not perform lay out, set up or 
assemble work on the table when the saw is in 
operation.

12.

TO PREVENT INJURIES, avoid awkward hand or 

finger positions, where a sudden slip could cause a 
hand to move into the blade when operating the saw.

13.

HOLD WORKPIECE FIRMLY against the table top.

14.

NEVER CUT MATERIAL that is too small to be held 

safely.

15.

DO NOT USE dull or bent blades.

16.

TURN THE SAW OFF AND UNPLUG THE CORD 

if the blade binds in the saw kerf while being backed 
out of the workpiece, usually caused by sawdust 
clogging the kerf. If this happens, turn off the scroll 
saw and unplug the power cord. Wedge open the 
kerf and back the blade out of the workpiece.

17.

DO NOT feed the material too fast while cutting. 

Only feed the workpiece at the rate the saw will cut.

18. 

TURN THE POWER OFF, make sure the scroll 

saw comes to a complete stop before installing or 
removing an accessory, and before leaving the work 
area.

19.

DO NOT START the saw with workpiece pressing 

against the blade. Slowly feed the workpiece into the 
moving blade.

20.

WHEN CUTTING a large workpiece, MAKE SURE 

the material is supported at table height.

21.

EXERCISE CAUTION when cutting workpieces 

that are round or irregularly shaped, workpieces can 
pinch the blade.

22.

ALWAYS release blade tension before loosening 

the blade holder screw.

23.

MAKE CERTAIN table tilting lock is tightened before 

starting the machine.

24.

NEVER REACH under the scroll saw table when 

motor is running.

25.

CHECK FOR DAMAGED PARTS before each 

use. Check for alignment of moving parts, binding 
of moving parts, breakage of parts, mounting or any 
other conditions that may affect operation. Parts that 
are damaged should be properly repaired or replaced 
before using the tool.

26.