Powermatic 2000 Benutzerhandbuch

 

11 

Referring to Figure 4: 

1. Thread 

the 

swivel handles (A) into the front and 

side  handwheels (C) and tighten with a 14mm 
wrench. 

2. Screw lock knobs (B) into the threaded 

openings on the end of the shafts located in the 
middle of the handwheels (C). 

Note: Do not tighten the lock knobs all the way 
at this time. 

 

 

Referring to Figure 5: 

The Model 2000 comes equipped with a dust chute 
and hose assembly (Inset 2) for use with a dust 
collection system. If you do not intend to use a dust 
collection system, the dust chute may be 
disconnected and removed as described below. 

To provide sufficient clearance for removal of the 
dust chute: 

1. Raise the blade height all the way up and set 

the  blade tilt to 0º (refer to Handwheel 
Adjustments on page 14). 

2. Remove 

the 

arbor nut and collar as described 

in the Blade Installation/Replacement on page 
12, steps 3-4. 

3. Remove 

two 

socket head button screws (D, E) 

with 4mm and 5mm hex wrenches respectively. 

4.  Through the opening on the left side of the 

cabinet, remove the hose (Inset 1, 2) by 
twisting and pulling back on the dust port (F). 

Take the entire assembly (Inset 2) out through 
the side opening. 

Do not replace the arbor nut and collar at this time, 
but proceed to the Blade Installation/Replacement 
section (following page).