Southbend SB1019 Benutzerhandbuch

For Machines Mfg. Since 8/09

Model SB1019

-29-

The headstock can be swiveled to cut angles from 

0–45° to the left and 0–45° to the right for a total 

swing of 90°. When making cuts to the right, the 

vise should remain in the left position. If you 

need to make a cut to the left, you will have to 

move the vise to the right side of the machine.

1.  DISCONNECT BANDSAW FROM POWER!

2.  Loosen the lock handle shown in Figure 

28, then swivel the headstock to the desired 

angle, using the angle scale as a guide.

3.  Move the saw through its full range of 

motion to make sure the blade will not 

contact the vise during operation, then 

tighten the swivel lock handle.

1.  DISCONNECT BANDSAW FROM POWER!

2.  Rotate the 0° flip stop out of the way, as 

shown in Figure 28. 

3.  Lift the headstock to the upmost position, 

then close the downfeed valve to prevent it 

from lowering.

Slide the vise to the right until it stops. 

Replace the cap screws that were removed 

in Step 4 into the holes indicated in Figure 

30. If needed, install the work stop on the 

left side of the vise.

4.  Remove the three cap screws that secure the 

vise to the machine base shown in Figure 

29.

6.  Move the saw through its full range of 

motion to make sure the blade will not 

contact the vise during operation, then 

tighten the swivel lock handle.