Grizzly G0636XB Benutzerhandbuch

Model g0636XB

-2-

figure 3. example of attaching resaw fence to

standard fence.

Moving

plate

resaw Fence

resaw lock

handle

figure 2. Fence handle components.

pivot Block

hex nut

Fence

handle

4. tighten the hex nut on the fence handle

against the fence pivot block (

figure 2).

6. tighten the resaw lock handle.

7. pull the fence handle up and place the fence

assembly on the rail.

8. push the fence handle down to lock the fence

assembly in place.

test run

1. Follow steps 1-3 in the g0636X Manual on

page 20.

2. Verify that the machine is operating correctly

by turning the switch disabling key (

figure 4)

to "1" and turning the machine

ON.

—When operating correctly, the machine

runs smoothly with little or no vibration or
rubbing noises.

— investigate and correct strange or unusual

noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.

3. press the oFF button to stop the machine.

4. Without resetting the oFF button, press

the on button. the machine should not
start.

—if the machine does not start, the oFF but-

ton safety feature is working correctly.

—if the machine does start (with the oFF

button pushed in), immediately disconnect
power  to  the  machine.  the  oFF  button
safety feature is not working correctly. this
safety  feature  must  work  properly  before
proceeding  with  regular  operations.  Call
tech support for help.

5. twist the oFF button clockwise so it pops

out. When the oFF button pops out, the
switch is reset and ready for operation (see

figure 5).

figure

. g0636XB switch disabling key and

on/oFF switch.

5. install the resaw fence lock handle (with the

8mm washer and moving plate) onto the
fence, then slide the resaw fence over the
moving plate as shown in

figure 3.

note: Leave the moving plate and lock
handle loose enough to slide on the resaw
fence.