Cisco Systems OL-6426-02 Benutzerhandbuch
B E TA D R A F T - C I S C O C O N F I D E N T I A L
14-11
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02
Chapter 14 Troubleshooting
Recovering a Lost Password
Reset the Router
To reset the router, follow these steps:
Step 1
If break is enabled, go to
. If break is disabled, turn the router off (O), wait 5 seconds, and turn it
on (|) again. Within 60 seconds, press the Break key. The terminal displays the ROM monitor prompt.
Go to
Go to
.
Note
Some terminal keyboards have a key labeled Break. If your keyboard does not have a Break key,
see the documentation that came with the terminal for instructions on how to send a break.
see the documentation that came with the terminal for instructions on how to send a break.
Step 2
Press break. The terminal displays the following prompt:
rommon 2>
Step 3
Enter confreg 0x142 to reset the configuration register:
rommon 2> confreg 0x142
Step 4
Initialize the router by entering the reset command:
rommon 2> reset
The router cycles its power, and the configuration register is set to 0x142. The router uses the boot ROM
system image, indicated by the system configuration dialog:
system image, indicated by the system configuration dialog:
--- System Configuration Dialog ---
Step 5
Enter no in response to the prompts until the following message is displayed:
Press RETURN to get started!
Step 6
Press Return. The following prompt appears:
Router>
Step 7
Enter the enable command to enter enable mode. Configuration changes can be made only in enable
mode:
mode:
Router> enable
The prompt changes to the privileged EXEC prompt:
Router#
Step 8
Enter the show startup-config command to display an enable password in the configuration file:
Router# show startup-config
If you are recovering an enable password, omit the following
section, and complete the password recovery process by performing the steps in the
section.
If you are recovering an enable secret password, it is not displayed in the show startup-config command
output. Complete the password recovery process by performing the steps in the following
output. Complete the password recovery process by performing the steps in the following
section.