Cisco Systems OL-6426-02 Benutzerhandbuch
A-4
Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide
OL-6426-02
Appendix A Cisco IOS Software Basic Skills
Getting Help
Getting Help
You can use the question mark (?) and arrow keys to help you enter commands.
For a list of available commands at that command mode, enter a question mark:
Router> ?
access-enable
Create a temporary access-list entry
access-profile Apply user-profile to interface
clear
Reset functions
...
To complete a command, enter a few known characters followed by a question mark (with no space):
Router> s?
* s=show set show slip systat
For a list of command variables, enter the command followed by a space and a question mark:
Router> show ?
...
clock
Display the system clock
dialer
Dialer parameters and statistics
exception
exception information
...
To redisplay a command you previously entered, press the Up Arrow key. You can continue to press the
Up Arrow key for more commands.
Up Arrow key for more commands.
Router
configuration
configuration
Enter one of the router
commands followed by
the appropriate
keyword, for example
router rip, from
global configuration
mode.
commands followed by
the appropriate
keyword, for example
router rip, from
global configuration
mode.
Router
(config-
router)#
•
To exit to global
configuration mode,
enter the exit command.
configuration mode,
enter the exit command.
•
To exit to privileged
EXEC mode, enter the
end command, or press
Ctrl-Z.
EXEC mode, enter the
end command, or press
Ctrl-Z.
Use this mode to configure an IP
routing protocol.
routing protocol.
Line
configuration
configuration
Enter the line
command with the
desired line number,
for example, line 0,
from global
configuration mode.
command with the
desired line number,
for example, line 0,
from global
configuration mode.
Router
(config-
line)#
•
To exit to global
configuration mode,
enter the exit command.
configuration mode,
enter the exit command.
•
To exit to privileged
EXEC mode, enter the
end command, or press
Ctrl-Z.
EXEC mode, enter the
end command, or press
Ctrl-Z.
Use this mode to configure
parameters for the terminal line.
parameters for the terminal line.
Table A-2
Command Modes Summary (continued)
Mode
Access Method
Prompt
Exit and Entrance Method
About This Mode