Cisco Systems OL-6426-02 Benutzerhandbuch

1-8

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

OL-6426-02

Chapter 1 Basic Router Configuration

Configuring Basic Parameters

Configure the ATM WAN Interface

This procedure applies only to the Cisco 1801, Cisco 1802, and Cisco 1803 models.

Perform these steps to configure the ATM interface, beginning in global configuration mode:

Command

Purpose

Step 1

For the Cisco 1803 only:

controller dsl 0
mode atm
exit

Example:

Router(config)# controller dsl 0

Router(config-controller)# mode atm

Router(config-controller)# exit

Router(config)#

For routers using the G.SHDSL signaling, perform
these commands. Ignore this step for routers using
ADSL signaling.

Step 2

interface type number

Example:

Router(config)# interface atm0

Router(config-int)#

Enters interface configuration mode.

Step 3

ip address ip-address mask

Example:

Router(config-int)# ip address

200.200.100.1 255.255.255.0

Router(config-int)#

Sets the IP address and subnet mask for the ATM
interface.

Step 4

no shutdown

Example:

Router(config-int)# no shutdown

Router(config-int)#

Enables the ATM 0 interface.

Step 5

exit

Example:

Router(config-int)# exit

Router(config)#

Exits interface configuration mode and returns to
global configuration mode.