Cisco Systems OL-6426-02 Benutzerhandbuch

B E TA D R A F T - C I S C O C O N F I D E N T I A L

4-7

Cisco 1800 Series Integrated Services Routers (Fixed) Software Configuration Guide

OL-6426-02

Chapter 4 Configuring PPP over ATM with NAT

Configure DSL Signaling Protocol

If you wish to change any of these settings, use one of the following commands in global configuration
mode.

•

dsl operating-mode (from the ATM interface configuration mode)

•

dsl lom integer

•

dsl enable-training-log

See the Cisco IOS Wide-Area Networking Command Reference for details of these commands.

Verify the Configuration

You can verify that the configuration is set the way you want using the show dsl interface atm 0
command from privileged EXEC mode.

Configuring SHDSL

Complete the following steps to configure the DSL controller in your router to use SHDSL signaling,
beginning in global configuration mode.

Command

Purpose

Step 1

controller dsl port

Example:

Router(config)# controller dsl 0

Router(config-controller)#

Enters the configuration mode for the DSL
controller.

Step 2

line-term {co | cpe}

Example:

Router(config-controller)# line-term co

Router(config-controller)#

Specifies if the DSL line is terminated at a central
office (CO) or at customer premises equipment
(CPE).

Step 3

exit

Example:

Router(config-controller)# exit

Router(config)#

Exits controller configuration mode, returning to
global configuration mode.

Step 4

mode protocol

Example:

Router(config)# mode atm

Router(config-controller)#

Specifies the mode of the DSL controller and
enters controller configuration mode.