Wagner SprayTech 9175 Benutzerhandbuch

English

Practice / Spraying Technique

IMPORTAnT: Be sure that the paint hose is free of kinks and clear of objects with sharp cutting edges.

1. Switch the pump ON (l). Turn the PRIME/SPRAY knob

to SPRAY. Turn the pressure control dial to maximum

pressure (+). The spray hose should stiffen as paint

begins to flow through it.

2. When motor shuts off, unlock the spray gun and spray a

test area to check the spray pattern.

The motor will cycle on and off automatically as it needs

pressure.
The pressure control dial can be be adjusted up or down

to achieve the desired spray pattern.

Good spray pattern

Paint tailing pattern

(pressure too low,

clogged tip)

The key to a good job is an even coating over the entire surface.

This is done by using even strokes. Follow the TIPS, below.

Tip:

Keep the spray gun at right angles to the

surface. This means moving your entire

arm back and forth rather than just flexing

your wrist.

Heavy Coat

Light Coat

Tip:

Keep the spray gun perpendicular to the

surface, otherwise one end of the pattern

will be thicker than the other.

Approximately

10 to 12 inches

Right way

Wrong way

Tip:

Trigger gun after starting the stroke.

Release the trigger before ending the

stroke. The spray gun should be moving

when the trigger is pulled and released.

Overlap each stroke by about 30%. This

will ensure an even coating.

Approximately

10 to 12 inches

Keep stroke

even

Start

stroke

End

stroke

Pull

trigger

Release

trigger

Move

steadily

If you expect to be away from your sprayer for

more than one hour, follow the Short-Term Storage

instructions (page 18).

SPRAY