Wagner SprayTech 110v Benutzerhandbuch

 

1

2

3

4

5

6

REPAIRS AT THE UNIT

This may only be carried out by a skilled elec-

trician. No liability is assumed for incorrect 

installation.

Switch the unit off.

Before all repair work: Unplug the power 

plug from the outlet.

1.  In models with a front cover unscrew the trigger housing 

with inlet valve (1) from the paint section (see inlet valve, 

10.2, sections 1 to 3) and remove the front cover (2) by 

unscrewing the screws.

2.  Remove the multi-function switch (3) by unscrewing the 

screws. 

3.  Remove the rear cover (4) by loosening the screws.

4.  Loosen the cable threaded joint (5).

5.  Loosen the wires in the mains terminal (6).

6.  Replace the unit connecting line.

 

(only an approved power cable with the designation H07-

RNF with a splash-proof plug may be used).

7.  Connect the green/yellow wire to the contact with the PE 

sign.

8.  Remount the covers carefully (do not squeeze any ca-

bles!)

9.  Screw the trigger housing back into place (see inlet valve, 

10.2, sections 3)

Despite the use of high-quality materials the highly abrasive 

effect of the paints means that wear can occur at the follow-

ing parts:

Inlet valve (spare part Order No.: 0344700)

For replacing refer to Section 10.2

(failure becomes noticeable through  performance loss and/or 

poor or no suction)

Outlet valve (spare part Order No.: 0341702)

For replacing refer to Section 10.3

(failure becomes noticeable through performance loss and/

or poor suction) The outlet valve is usually considerably more 

durable than the inlet valve. Thorough cleaning may already 

help here.