Wagner SprayTech 558023 Benutzerhandbuch

ProSpray 3.29 • 3.31

Cleaning the unit (shutting down)

Cleaning the unit (shutting down)

A clean state is the best method of ensuring operation without

problems. After you have finished spraying, clean the unit. Under no

circumstances may any remaining coating material dry and harden in

the unit.
The cleaning agent used for cleaning (only with an igni tion point

above 21 °C) must be suitable for the coating material used.

• Secure the spray gun, refer to the operating manual of the

spray gun.

Clean and remove tip.
For a standard tip, refer to Page 19, Section 12.2.
If a non-standard tip is installed, proceed according to the relevant

operating manual.
  1.  Remove suction hose from the coating material.
2. Close the relief valve, valve position SPRAY (p spray).
  3.  Switch the unit ON.
  4.  Pull the trigger of the spray gun in order to pump the

remaining coating material from the suction hose, high-

pressure hose and the spray gun into an open container.

Attention

The container must be earthed in case of coating

materials which contain solvents.

Caution! Do not pump or spray into a container with

a small opening (bunghole)!
Refer to the safety regulations.

5. Immerse suction hose with return hose into a container with a

suitable cleaning agent.

6. Turn the pressure control knob into the blue zone - pulsating

pressure for unit cleaning.

  7.  Open the relief valve, valve position PRIME
   (k circulation).
  8.  Pump a suitable cleaning agent in the circuit for a few

minutes.

9. Close the relief valve, valve position SPRAY (p spray).
10. Pull the trigger of the spray gun.
11. Pump the remaining cleaning agent into an open container

until the unit is empty.

12. Switch the unit OFF.

8.1

cleaning unit from outside

First of all pull out mains plug from socket.

Attention

Danger of short circult through panetrating water!
Never spray down the unit with high-pressure or

high-pressure steam cleaners.

Attention

Do not put the high-pressure hose into solvents.

use only a wet cloth to wipe down the outside of the

hose.

Wipe down unit externally with a cloth which has been immersed in a

suitable cleaning agent.

8.2

Cleaning the high-pressure filter

Clean the filter cartridge regularly.
A soiled or clogged high-pressure filter can cause a poor spray

pattern or a clogged tip.
1. Turn the pressure regulator knob into the black zone until it

stops (no pressure).

2. Open the relief valve, valve position PRIME

(k circulation).
3. Switch the unit OFF.

unplug the power plug from the outlet.

4. Unscrew the filter housing (Fig. 9, Item 1). with a strap wrench.
5. Pull the filter cartridge (2) from the bearing spring (3).
6. Clean all the parts with the corresponding cleaning agent. If

necessary, replace the filter cartridge.

7. Check the O-ring (4), replace it if necessary.
8. Place the bearing ring (5) against the bearing spring (3). Slide

the filter cartridge (2) over the bearing spring.

9. Screw in filter housing (1) and tighten it as far as possible with

the strap wrench.