Delta 22-555 Benutzerhandbuch

12

Disconnect the machine from the 

power source before making any 

adjustments!

Planer knives are dangerously sharp. 

Use extreme caution when inspecting, 

removing, sharpening, or replacing knives into the cutter 

head. Failure to comply may cause serious injury.

1.  Remove the dust chute by unscrewing the two lock 

knobs shown in Figure 2.

2.  Remove the two lock knobs securing the cutterhead 

cover to the main casting and remove the cover. The 

cutterhead and the knives will now be exposed. 

3.  Lock the cutterhead in place. To do this, refer to 

Figure 7 and ensure the red spring-loaded lock tab (A) 

is in the forward position. Then carefully and slowly 

rotate the cutterhead until the tab locks in place and 

the cutterhead does not move. 

4.  Using the T-handle hex wrench supplied, loosen the 

six screws (B) securing each knife hold down bar and 

the knife to the cutterhead.

5.  Use the magnetic end of the knife removal tool (C) to 

carefully lift off the hold down bar and then the knife.

Blades are sharp! Use great care when 

1.  Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp 

cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

2.  Periodically check tightness on all other hardware and listen for any unusual vibrations as you work as these may be 

a sign of loose hardware. 

hands are around blade area!

6.   Carefully install the new knife or rotate the existing 

knife, ensuring the pins on the cutterhead align with 

the elongated holes in the knife.

7.  Replace the hold down bar, making sure that the two 

pins on the cutterhead are aligned with the two small 

holes in the hold down bar.

8.  Replace and retighten the six screws. 
9.  Unlock the cutterhead by moving the red spring-

loaded lock tab forward and carefully rotating the 

cutterhead until the second knife is exposed and the 

cuttterhead locks into place. 

10. Repeat Steps 4 – 8 to replace the second knife.
11. Replace the cutterhead cover. Ensure the notches in 

the cover align with the threaded holes and the cover 

is fully seated in the recess.

12.  Replace the dust chute and re-secure with the two 

lock knobs.