Southbend SB1001 Benutzerhandbuch
For Machines Mfg. Since 8/11
Model SB1001 8K
™
Lathe
-51-
S E R V I C E
Grease Fittings
Grease Type ............................................... NLGI#2
Lubricating Device ...............Included Grease Gun
Amount ................................................. 1–2 Pumps
Frequency ....................................................... Daily
Lubricating Device ...............Included Grease Gun
Amount ................................................. 1–2 Pumps
Frequency ....................................................... Daily
The exact amount may vary slightly for each
fitting on the machine. If excessive grease is seen
exiting between the parts, reduce the amount
added.
fitting on the machine. If excessive grease is seen
exiting between the parts, reduce the amount
added.
There are 10 grease fittings on the Model SB1001
that require daily lubrication with the included
grease gun. Refer to Figures 82–85 for the
locations of these fittings.
that require daily lubrication with the included
grease gun. Refer to Figures 82–85 for the
locations of these fittings.
Figure 84. Carriage grease fittings.
3
Fittings
Figure 83. Left leadscrew bushing grease fittings.
Leadscrew
Fitting
Figure 85. Tailstock and right leadscrew bushing
grease fittings.
Leadscrew
Fitting
Tailstock
Fittings
Figure 82. Five grease fittings inside end cover.
3
Fittings
Longitudinal Leadscrew
Oil Type ...... Mobil Vactra 2 or ISO 65 Equivalent
Amount .................................................. As Needed
Frequency ....................................................... Daily
Amount .................................................. As Needed
Frequency ....................................................... Daily
Before lubricating the leadscrew, clean it first
with mineral spirits and a stiff brush. Make sure
to move the carriage so that you clean the entire
length of the leadscrew.
with mineral spirits and a stiff brush. Make sure
to move the carriage so that you clean the entire
length of the leadscrew.
Apply a thin coat of oil along the length of the
leadscrew. Use a clean stiff brush to make sure
the oil is applied evenly and down into the
threads.
leadscrew. Use a clean stiff brush to make sure
the oil is applied evenly and down into the
threads.
Note:
In some environments, abrasive material
can become caught in the leadscrew lubricant
and drawn into the half nut. In this case,
lubricate the leadscrew with a quality dry
lubricant.
and drawn into the half nut. In this case,
lubricate the leadscrew with a quality dry
lubricant.