Eagle Electronics EGA530 Benutzerhandbuch

5

Wear hearing protection.

Wear eye protection.

Wear respiratory protection.

Read the instruction manual

Do not put additional pressure on the tool, this will only reduce efficiency and shorten the 

tool’s life. We recommend the air pressure of this grinder at 90 PSI.

When using the grinder be careful not to exert excessive force. Too much force could be 

hazardous if it caused the cutting tool spindle to bend or break.

The burning of the work piece or excessive speed reduction indicates too much force being 

applied. Changing to a cutting tool may be better for the desired rate of speed and stock 

removal.

Avoid hazardous conditions by making sure there is sufficient gripping force on the spindle 

of cutting tool by placing the spindle 7/16” or more inside the collet.

Lubricate the motor with a good grade of air tool oil. Grit or gum deposit in the tool may cut 

power and may be corrected by cleaning the air strainer and flushing out the tool with gum 

solvent oil.

To ensure long life be sure to oil the tool daily. Pour 4 drops of Eagle air tool (SEA 20 non 

detergent) oil into the air inlet, and then run the tool for a few seconds to clean.

The hammer mechanism of this tool also needs to be greased from time to time (depending 

on usage). The tool is equipped with grease fitting for this purpose; use this connection to 

re-grease the tool using Eagle impact wrench grease. 

Air tool does not 

run or runs slow.

Lack of lubrication.

Lubricate as per instructions.

Dirt in tool.

Clean with mixture of 50/50 tool 

oil/solvent. Lubricate after cleaning.

Insufficient air pressure.

Check regulator and air supply for 

leaks. Check compressor to make 

sure it operates at correct pressure. 

Make sure air hose is properly sized 

and that multiple hoses are not 

connected to same outlet. Check air 

hose for leaks and repair.

Rotor blades worn or motor 

bearing worn or dirty.

Replace blades, inspect clean or 

replace bearing.

IMPACT WRENCH 

does not impact or 

impacts slowly.

See causes (above).

See remedies (above).

Broken or worn impact 

mechanism.

Inspect and repair as required.