Zenoah HTZ7510 Benutzerhandbuch

■ STARTING THE ENGINE

1. [HTZ7510] Make sure that the

throttle lever is at idling position. 
[CHTZ6010] Release the throttle
lever and make sure it is fully
back. (F1)

2. [CHTZ6010] Set the engine switch

to the “I (RUN)” position. (F1)

3. P u s h   t h e   p r i m e r   p u m p   u n t i l

overflown fuel flows out in the
clear tube. (F2)

4. M o v e   t h e   c h o k e   l e v e r   t o   t h e

closed position. (F3)

5. Place the unit on a flat, firm place.

Keep the cutting head clear of
everything around it.

6. While holding the unit firmly, pull

out the starter rope quickly. (F4)

•

Avoid pulling the rope to its end or
returning it by releasing the knob.
Such actions can cause starter
failures.

7. Move the choke lever downward

to open the choke. and restart
engine. (F3)

8. Allow the engine to warm up for a

several minutes before starting
opertion.

1. W h e n   r e s t a r t i n g   t h e   e n g i n e

i m m e d i a t e l y   a f t e r   s t o p p i n g   i t ,
leave the choke open. (F3)

2. Overchoking can make the engine

hard to start due to excess fuel.
When the engine failed to start
after several attempts, open the
choke and repeat pulling the rope,
or remove the spark plug and dry
it.

■ STOPPING THE ENGINE (F1)
[HTZ7510]
1. Please return the throttle lever

completely.

2. Press the stop switch until the

engine comes to a complete stop.

[CHTZ6010]
1. Release the throttle lever.
2. Move the engine switch to the

“O(STOP)”position.

I f   t h e   e n g i n e   d o e s n ’ t   s t o p   a f t e r
stopping the switch, close the choke
so that engine will stop after a little.