Remington Power Tools BS1812A Benutzerhandbuch

8

1. Remove 

fi ve mounting screws taped to 

underside of cutting guard.

2. 

Place cutting guard over spool housing at 
a slight angle.  Push guard back depressing 
tabs toward front of cutting guard. (See 
fi gure 4). Drop back of cutting guard into 
place.

3.  Slide cutting guard forward. (See fi gure 

5)

4.  Insert mounting screw into hole near-

est tabs in cutting guard. Tighten screw 
fi rmly. (See Figure 6)

5. 

Insert two mounting screws into holes at 
back of cutting guard. (See Figure 7)

6.  Place edging wheel over remaining two 

screw holes at front of cutting guard.  At-
tach edging wheel using two mounting 
screws. (See Figures 8 and 9)

1.  Remove the knob and bolt from front 

handle (see Figure 10).

2.  Place the handle on the trimmer/edger 

shaft between the rear handle and shaft 
collar. Snap handle onto shaft (see Figure 
11). 

3. 

Insert bolt back into the front handle (see 
Figure 12).

3. 

Adjust handle to the most comfortable po-
sition and tighten the knob fi rmly. Do not 
overtighten the knob. (See Figure 13).