Ridgid R839 Benutzerhandbuch

Seite von 16
2
3
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS. 
Failure to follow all instructions listed below, may 
result in electric shock, fire and/or serious personal 
injury.
SAVE THESE INSTRUCTIONS
WORK AREA
Keep  your  work  area  clean  and  well  lit.  Cluttered 
benches and dark areas invite accidents.
Do not operate worklight in explosive atmospheres, 
such as in the presence of flammable liquids, gases, 
or dust.
ELECTRICAL SAFETY
A battery operated worklight with integral batteries 
or a separate battery pack must be recharged only 
with the specified charger for the battery. A charger 
that may be suitable for one type of battery may create 
a risk of fire when used with another battery.
Use battery operated worklight only with specifically 
designated battery pack. Use of any other batteries may 
create a risk of fire.
Use battery only with charger listed.
 
MODEL 
BATTERY PACK 
CHARGER
 
R829 
130252002 
140276001
 
 
130254001 
140276002
 
 
R839 
130252003 
140276001
   
                      130254002              140276002
   
 
 
WORKLIGHT USE AND CARE
When battery pack is not in use, keep it away from 
other metal objects like: paper clips, coins, keys, nails, 
screws, or other small metal objects that can make 
a connection from one terminal to another. Shorting 
the battery terminals together may cause sparks, burns, 
or a fire.
SERVICE
Worklight service must be performed only by qualified 
repair personnel. 
Service or maintenance performed by 
unqualified personnel may result in a risk of injury.
When servicing a worklight, use only identical replace-
ment parts. Follow instructions in the Maintenance 
section  of  this  manual.
  Use  of  unauthorized  parts  or 
failure to follow Maintenance Instructions may create a 
risk of shock or injury.
SPECIFIC SAFETY RULES
n
   
Know your worklight. Read operator’s manual care-
fully. Learn its applications and limitations, as well as 
the specific potential hazards related to this worklight.
 
Following this rule will reduce the risk of electric shock, 
fire, or serious injury.
n
 
Lens and bulb become hot during use:
�  • During  or  immediately  after  use,  don’t  lay  worklight 
flat on lens surface or place lens area in contact with 
a plastic or fabric covered surface.
  • Handle  worklight  with  care  around  any  flammable 
surface.
  • Let worklight cool for several minutes after use before 
changing bulb.
  • Do not use or permit use of worklight in bed or sleeping 
bags. This worklight lens can melt fabric and a burn 
injury could result.
n
   
Use only the charger recommended for use with your 
worklight. 
Do not substitute any other charger. Use of 
another charger could cause batteries to explode causing 
possible serious injury.
n
   
Do not charge battery pack in a damp or wet loca-
tion. 
Following this rule will reduce the risk of electrical 
shock.
n
   
Your battery worklight should be charged in a location 
where the temperature is more than 50°F but less than 
100°F.
n
   
Under  extreme  usage  or  temperature  conditions, 
battery leakage may occur.
 If liquid comes in contact 
with your skin, wash immediately with soap and water, 
then neutralize with lemon juice or vinegar. If liquid gets 
in your eyes, flush them with clean water for at least 10 
minutes, then seek immediate medical attention.
n
 
Batteries vent hydrogen gas and can explode in the 
presence of a source of ignition, such as a pilot light.
 
To reduce the risk of serious personal injury, never use 
any cordless product in the presence of open flame. An 
exploded  battery  can  propel  debris  and  chemicals.  If 
exposed, flush with water immediately.
n
 
Never use a battery pack that has been damaged or 
received a sharp blow.
 A damaged battery pack is sub-
ject to explosion. Properly dispose of a damaged battery 
pack immediately. Failure to heed this warning can result 
in serious personal injury.
n
   
Use only recommended battery pack with your work-
light.
 Any attempt to use another battery pack will cause 
damage to your worklight and could possibly explode, 
cause a fire, or personal injury.
n
   
Remove battery pack from worklight before replac-
ing bulb or performing any routine maintenance or 
cleaning.
n
   Do not disassemble your worklight.