Heath Zenith UT-5571-BZ Benutzerhandbuch

White to White

Black to Black

© 2007 HeathCo LLC

 

598-1298-01

Canopy

Questions or problems? Before returning to your retailer, call our 
technical service department at 1-800-858-8501 (English speaking 
only), 7:30 am to 4:30 pm, CST, Monday – Friday.

This quartz halogen fl oodlight disperses light over a wide area, at-
taches to a standard junction box and is for use with 120 VAC.

• Floodlight 

• Bulb

•  2 Rubber plugs 

•  Gasket

• Wire 

connectors 

• Mounting 

hardware

NOTE:  All wiring must be run in accordance with the National 

Electrical Code through conduit or another acceptable 
means. Contact a qualifi ed electrician if there is any ques-
tion as to the suitability of the system.

Estimated Installation Time: 30 minutes

Items needed for installation (not included):
•  Phillips and fl athead screwdrivers
• Pliers 

• Wire 

strippers/cutters

•  Safety glasses 

•  Silicone caulk

• Ladder 

• Black 

tape

• Allow fi xture to cool before touching. The bulbs and fi xture 

operate at high temperatures.

• Keep fi xture at least 2" (51 mm) from combustible materials. 

Do not aim at objects closer than 3 feet (1 m).

• Replace bulb with up to 150W (max.) T3 halogen 120 VAC bulb 

only.

247590

UT-5571-BZ

•  Follow all warnings listed on fi xture.
•  Grounding and installations must comply with local codes and 

the National Electric Code.

•  This product should be mounted on a grounded junction box and 

must be used with the canopy included.

•  Permanently mount the fi xture to a building or pole.

1.  Thread aiming arm into the enclosed canopy and tighten. Apply 

silicon caulk to joint for a raintight seal. Seal the remaining holes 
with the enclosed canopy plugs.

2. Connect the fi xture wires to the power source wiring. Secure 

with wire connectors.

3.  Attach the canopy to the junction box (Apply silicon caulk be-

tween canopy and junction box for a raintight seal). Keep the 
fi xture horizontal (within +/- 4º) so the bulb inside is horizontal. 
If the bulb is not horizontal, the bulb may darken or shatter 
and fail prematurely.

1. When replacing bulb, turn power off and let the fi xture cool.

2.  Remove glass cover and remove the old bulb by pushing the 

bulb towards the right until the left side of the bulb is clear of 
the left socket.

3.  To insert the new bulb push the bulb into the right socket so the 

bulb is properly seated in the sockets.

4.  Re-install the glass cover.

5.  Reconnect the power.

IMPORTANT: Use a clean glove or cloth when handling the 
new bulb. Oil from your hand may cause the bulb to crack when 
the fi xture heats up and result in premature failure. Use isopro-
pyl (rubbing) alcohol to clean the bulb if it is touched with your 
bare hands.

4.  Loosen the side bolt connected to the arm to aim the fi xture up 

and down.

5.  To avoid water entering fi xture, do not aim the fi xture above the 

horizon.