Cub Cadet 421R Benutzerhandbuch

5

•

Cut along corners of the carton and lay it down flat. 
See Figure 1. Remove packing material. 

•

Remove any loose parts included with unit (i.e., 
operator’s manual, etc.).

•

Roll unit out of carton. Check carton thoroughly for 
any remaining loose part.

1.

Ignition Keys* (2) 

*One key may be in the switch on snow thrower.

 

(Items 2 to 5 are illustrated in Figure 2.)

2.

Eyebolt

3.

Saddle Washer 5/16" I.D.

4.

Hex Nuts 5/16-18 Thread (2)

5.

Cotter Pin

1.

Pair of pliers (not necessary, but helpful)

2.

Two cycle engine oil (included)

3.

Fresh gasoline

NOTE:  All references to left or right side of the snow
thrower is from the operating position only.

Disconnect the spark plug wire

and ground it against the engine to prevent
unintended starting.

•

Loosen the hand knob on each side of the handle. 
Remove packing material, if any.

•

Raise the upper handle in the direction shown in 
Figure 3 till it clicks into the operating position. 
Make sure not to pinch or crimp the cable.

•

Tighten the hand knobs.

The control cable may already be attached to the 
control handle. If not attached, complete the following 
steps to attach it to the snow thrower housing.

•

Route the control cable over the lower handle. 
Insert the end of the cable into the hole in the 
control housing as shown in Figure 4. Push the 
plastic fitting until it locks into the control housing.

Roll unit out

Remove loose parts

Raise 
handle 
to here