Heath Zenith UT-5677-BZ Benutzerhandbuch

2.  Connect the fixture wires to the junction box wires (black 

to black, white to white, and the fixture ground wire to the 
junction box ground wire). Secure with the wire connectors
provided.

3.  Secure the cover plate (not included) to the outdoor weatherproof

junction box (not included) with two screws (not included).

4.  Apply  weatherproof  silicone  caulking  around  cover  plate  to

provide a watertight seal.

5.  Adjust the fixture to aim in the general direction desired. If pos-

sible, turn the light fixture so the photocontrol* does not point
at another light or reflective surface near the fixture.

6.  When you have the floodlight aimed where you want it, tighten

the lock nut on the mounting arm and the locking screw at the
fixture joint.

7.  Release the clasp that holds the lens closed.

Model 5675 - Install ONLY a 100 watt mercury vapor type
H38 bulb (provided).

Model 5677 - Install ONLY a 70 watt high pressure sodium
type S62 bulb (provided).

8.  Close the lens and lock it shut with the clasp.

To test operation during daylight, cover the photo control with black
tape. Turn on the power. The light will take up to ten minutes to reach
full brightness. Remove the tape from the photo control and your unit
will operate automatically—on at dusk, off at dawn.

If your floodlight does not turn on automatically or cycles on and off,
it could be affected by other nearby lights or is seeing its own light.
In either case, loosen the plastic nut that secures the photocontrol.
Slide the metal reflector under the nut so that the reflector causes the
photocontrol to look away from nearby lights or reflective surfaces
and retighten the plastic nut.

Cover Plate

Junction Box

Gasket

Metal Reflector

Mounting 

Arm

Photocontrol

Fixture

Lock Nut

Locking Screw

© 2007 HeathCo LLC 

598-1287-03

Questions or problems? Before returning to your retailer, call our
technical service department at 1-800-858-8501 (English speaking
only), 7:30 am to 4:30 pm, CST, Monday – Friday.

•  Floodlight

•  Bulb

•  Wire connectors

Estimated Installation Time: 30 minutes
Items needed for installation (not included):
•  Phillips and flathead screwdrivers
•  Pliers

•  Wire strippers/cutters

•  Safety glasses

•  Silicone caulk

•  Ladder

•  Black tape

NOTe:  All wiring must be run in accordance with the National

Electrical  Code  (Canadian  Electrical  Code  in  Canada)
through conduit or another acceptable means. Contact a
qualified electrician if there is any question as to the suit-
ability of the system.

247589

UT-5675-BZ

247588

UT-5677-BZ

1.  Install light fixture to an approved outdoor weatherproof junction

box cover plate (not included).