Heath Zenith SL-5660 Benutzerhandbuch

© 2007 HeathCo LLC 

598-1089-03

1.  Select a location on a fl at wall with structurally sound wood and 

from 10 to 25 feet (3 to 7.6 m) from the ground. The wood should 
be at least one inch (25 mm)thick to safely secure the fi xture.

2.  Using the mounting template as a guide, mark the 3 mounting holes. 

We suggest drilling 3/16" (4.8 mm) pilot holes for the lag screws.

3.  Install the two bottom lag screws fi rst. Screw in the lag screws 

so that there is about 3/8" (9.5 mm) of space under the head.

4.  Place the fi xture on these two screws and install the top lag screw. 

Tighten the top lag screw fi rst, then tighten the remaining lag 
screws.

5.  Secure your outdoor cable or fl exible conduit to the cover plate 

with a fi tting in accordance with the National Electrical Code.

6.  Thread the black and white fi xture wires through the hole in the 

cover plate as shown.

7. Connect the fi xture wires to the service wires (black to black 

and white to white).

8. This fi xture must be connected to ground. Secure the service 

ground wire under the head of the green ground screw.

9.  Install the cover plate. Secure with the two screws and nuts 

provided.

10. Install the refl ector/lens assembly. Secure with the two screws 

and washers provided.

11. Screw in the 70 watt H.P. Sodium type S62 lamp provided.
12. Loosen the screw in the center of the photocontrol socket two 

turns. Twist the socket so that the arrow points north. Note: There 
is a stop to prevent the socket from turning all the way around. If 
you have trouble turning the socket, try turning it the other direc-
tion. Retighten the screw in the center of the socket.

13. Align the photocontrol (it will only plug-in one way). Plug it in 

and twist clockwise until it stops.

NOTE:  All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through 

conduit or another acceptable means. Contact a qualifi ed electrician if there is any question as to the suitability of 
the system.

Ground 

Screw

Fixture wires thru 

this hole

Photocontrol

Lens/Refl ector 

Assembly

Cover Plate

To test operation during daylight, cover the photocontrol with a small box. Turn on the power. Not all photocontrols are alike. Some may 
have a time delay of a few minutes, others will turn on as soon as power is applied. The light will take up to ten minutes to reach full 
brightness. Uncover the photocontrol and your unit will operate automatically—on at dusk, off at dawn.

 WARNING: Turn power off at the fuse or circuit