Heath Zenith SL-5210 Benutzerhandbuch

Features

• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight hours.

Requirements

• The light control requires 120-volts AC.
• If you want to use Manual Override, the control must be

wired through a wall switch.

•

Some codes require installation by a qualified
electrician.

• Switch Module mounts into a standard 4" x 4" junction box.

The SL-5210 package includes:
• The Sensor Module and Switch Module
• Three wire nuts
• Two sensor module screws

595-4991-07

Motion Sensor
Decorative Lighting
Control

Model SL-5210

Switch Mod-

ule In Junction

Box Behind

Light Fixture

Sensor Module

Sensor Cord

Existing Light Fixture

Typical Installation

Drip Loop

NOTE: The Drip Loop is neccessary to prevent rain from
running down the cord to the Sensor Module.

OPERATION

Move ON-TIME Switch to 1,

5, or 10 minutes

Mode Switching Summary

Flip switch off for one
second then back on*

* resets to Auto Mode at dawn.

TEST

AUTO

MANUAL MODE

ON-TIME

* If you get confused while switching modes, turn the power

off for one minute, then back on. After the calibration time
(1

min.) the control will be in the AUTO mode.

10 5 1

TEST

10 5 1 TEST

MANUAL MODE

AUTO

TEST

... back on.

1 Second OFF

then...

Manual mode only works at night because
daylight returns the sensor to AUTO.

Flip the light switch off for one second
then back on to toggle between AUTO and
MANUAL MODE.

Manual mode works only with the ON-TIME
switch in the 1, 5, or 10 position.

Note: When first turned on wait about 1

minutes for the

circuitry to calibrate.

Put the ON-TIME switch in the 1, 5, or 10
minute position.

Put the ON-TIME switch on the bottom of the
sensor in the TEST position.

Mode:

On-Time:

Works:

Day

Night

Test

5 Sec

Normal

1, 5, 10 min.

Manual

Until Dawn*