Cisco Systems 6020 IP Benutzerhandbuch

Install the 6020 IP camera using one of the following procedures:

To directly mount the 6020 IP camera to a surface, complete the following steps:

Attach the included alignment sticker to the ceiling or wall.

Using the circle marks on the sticker, drill 2 pilot holes symmetrically on each side into the ceiling or 
wall. Then hammer the included wall anchors into the holes.

Secure the IP camera to the ceiling or wall with the included screws.

Connect an STP (shielded twisted pair) Category 5 or higher network cable to the LAN port on the back 
of the camera. Connect the other end of the network cable to a 10/100/BaseT router or switch. 

If your network provides PoE, the IP camera powers on.

(Optional) Connect the following cables to the GPIO terminal block:

External power cable if Power over Ethernet (PoE) is not available.

I/O cables for external input or out put devices, such as sensors or alarms.