Cisco Systems 6020 IP Benutzerhandbuch

Complete the following procedures: 

After you install the IP camera, follow the instructions in the 

 to access the IP camera through your network. 

After completing the initial setup, use the IP camera user interface to adjust the focal length and 
zoom factor. For more information, see the 

To mount the 6020 IP camera using a vandal resistant (VR) enclosure, complete the following steps:

Attach the included alignment sticker to the ceiling or wall.

Using the circle marks on the sticker, drill at least 2 pilot holes symmetrically on each side into the 
ceiling or wall. Then hammer the included plastic anchors into the holes.

Do one of the following:

To feed cables through a ceiling or wall, cut out a section of the ceiling or wall that corresponds to 
the triangular cutout on the alignment sticker.

To feed cables through the side of the conduit base, use a screwdriver to remove the cutout on the 
side of the conduit base.

Secure the conduit base to the ceiling or wall with two included screws.