Lenco Marine LP-2000 Merkblatt

The Mark II welder makes factory type spot welds in the shop.  Simple to operate 
by pressing the two electrodes against the work and pressing the trigger.

• Time of welds is automatic by solid state electronics
• Protected control panel
• On/Off indicating switch
• Maximum welding capacity is 20 ga. autobody steel
• Tool storage space
• Easy portability with wheeled car t
• Primary voltage is 208/230 single phase 50/60 Hz,
  50 amp or 480 single phase 50/60 Hz, 30 amp
• Shipping weight is 110 lbs.
• 50’ Power cable

• Star weld tip welds directly to the work piece
• Built on slide hammer for one step operation
• Can shrink light gauge metals
• Available with primary voltage of 208/230 single phase 50/60 

Hz, 20 amp or 120 volts 50/60 Hz, 30 amp

• 7’ welding & 7’ ground cable leads
• Shipping weight is 64 lbs.
• 25’ Power cable

L-4000

20400

208/230

L-4480*

20480

480

LP-2000

20720

208/230

LP-2000

20820

120

• T-handle can be used for short controlled pulls
• Lightweight, padded grip for comfortable usage
• Can shrink light gauge metals
• Available with primary voltage of 208/230 single phase 50/60 

Hz, 20 amp or 120 volts 50/60 Hz, 30 amp

• 10’ welding & 7’ ground cable leads
• Shipping weight is 64 lbs
• 25’ Power cable

HP-2010

20710

208/230

HP-2010

20810

120

Lenco dent pulling systems allow for 

any type of pull in any situation.  

Systems have their own specially 

designed transformers and are 

available in 120 or 230 VAC.

*w/o power cable