Bad Boy Mowers 02.9812.0001C Benutzerhandbuch

A male XLR DMX512 termination connector is required at the last 
luminaire (or "far end of the line") to prevent signal reflections.  Signal 
reflections may cancel out the signal at certain line lengths, resulting in 
errors.  The terminator is also necessary for software downloads and 
running tests on multiple luminaires.

  

To construct your own connector, 

you will need the following components:
•

5-pin, male XLR connector.

•

120 ohm resistor.

Note:  A male termination connector is also available as an accessory from PRG. See 

on page 7.

The Bad Boy Luminaire is equipped with two RJ-45 type connectors for Ethernet input/output. 
Ethernet cabling should follow these guidelines:
•

Ethernet cable assemblies must match the CAT5e specification. 

•

Regular or crossover cables are acceptable. 

•

Both EtherCon® and RJ-45 connectors are acceptable.