Bad Boy Mowers 02.9812.0001C Benutzerhandbuch
B
AD
B
OY
™ S
POT
L
UMINAIRE
U
SER
M
ANUAL
1 6
02.9812.0001C
Vertical "Yoke Out" Hang
The Bad Boy™ Spot Luminaire can be hung in a vertical position, if required. In this configuration,
the luminaire should be positioned so that the interface panel (display) is facing downward for ease of
programming.
the luminaire should be positioned so that the interface panel (display) is facing downward for ease of
programming.
WARNING: The luminaire is heavy. Use caution when lifting.
WARNING: The vertical configuration requires 3 people to hang and secure the luminaire.
WARNING: Two safety cables and at least two truss hooks should be used in all hang configurations.
To install in vertical hang:
Step 1. Orient Hanging Brackets as shown in
Step 1. Orient Hanging Brackets as shown in
.
Step 2. Place Hanging Bracket down over
buttons and slide until bracket locks
into place (you will hear a "click"
when bracket is locked).
into place (you will hear a "click"
when bracket is locked).
CAUTION: Hanging Brackets must be
installed in the orientation shown in
installed in the orientation shown in
so that the interface panel (display) will face
downward.
downward.
Step 3. Roll case to mounting location as
Step 4. Using two people, carefully lift
luminaire into mounting position so
that display is facing downward.
that display is facing downward.
Step 5. Using a third person, secure in place
by tightening Truss Hook wing bolts.
Ensure that luminaire is fully supported.
Ensure that luminaire is fully supported.
Step 6. Feed safety cables through mounting bracket slots and secure around pipe.
Step 7. Connect power and data cables according to
Step 7. Connect power and data cables according to
Figure 2-6: Attaching Hanging Brackets