Bad Boy Mowers 02.9812.0001C Benutzerhandbuch

The following table provides a list of common start-up problems and possible solutions.

No power to luminaire.

Ensure power cable is properly connected to Neutrik 
input connector.

Ensure power is switched on at source (mains, discon-
nect box, etc.)

n/a

No console control.

Ensure DMX512 or Ethernet data cable is properly 
connected.

Ensure DMX512 address setting is correct.

DMX512 control not working cor-
rectly throughout daisy-chain.

Ensure data cables are correctly configured.

Ensure termination connector is installed at last lumi-
naire in data link.

Lamp does not strike at power-up.

Configure lamp to start at power-up.

Comm LED is red indicating that no 
valid DMX or Ethernet signal is 
detected.

Ensure DMX512 or Ethernet data cable is properly 
connected.
Check console.

No Ethernet control.

Ensure that luminaire is not also receiving a DMX sig-
nal. If both valid DMX and Ethernet control are being 
received, DMX control will take precedence.

Beam obstructed by gobo in open 
position.

Set new gobo zero position.

Luminaire won’t take software 
update.

Remove active control (DMX512 or Art-Net).