3com Switch 4500 PWR 50-Port Benutzerhandbuch

Figure 18   User View Login via Telnet

4 Enter the system-view command and Enter.

5 Enter interface vlan 1 and Enter.

6 Enter the IP address and subnet mask for the Switch as follows:

(where xxx.xxx.xxx.xxx is the IP address and mmm.mmm.mmm.mmm is 
the subnet mask of the Switch)

7 Enter the default gateway for the Switch:

(where xxx.xxx.xxx.xxx is the IP address of the default gateway)

8 From the User View, enter the save command to save the configuration 

to your Switch as the configuration is not saved automatically when the 
Switch is powered down.

The initial set up of your Switch is now complete and the Switch is ready 
for you to set up your chosen management method. See “Methods of 
Managing a Switch” on page 38.

If you allow the Switch to automatically configure its own IP information 
you need to discover and view the IP information before you can begin to 
manage the Switch. You can discover the IP information in two ways:

■

Using 3Com Network Director — this application will auto-discover 
the Switch and display the automatically allocated IP information 
assigned to the Switch.